Ford FICM Repair

Ford 2003-2007 6.0 PowerStroke(FICM) Fuel Injection Control Module Repair.

Ford Power-stroke 6.0 Diesel F250-F350-F450-F550



No Programming Required


This is a Repair for Ford Fuel Injection Control Modules (FICM)
If your are experiencing NO Start,Hard Start,Runs Rough especially in cold weather or PO611 code, you most likely need your FICM repaired.
Test Procedure:
4 pin (most Common).
  • Remove Rectangular cap held on with 2, T20 torque screws.
  • Connect Positive lead of Volt meter to screw closest to drivers side fender***Only touch the screw, be careful not to short to FICM case.
  • Connect ground lead to a good clean ground.
  • With assistance turn Ignition key on, voltage should increase to 48.3. Make sure your clear of fan & belt and crank engine. If the voltage is below 45 volts your FICM isn’t performing like it should providing you have GOOD BATTERIES and CABLES.
7 pin
  • Same procedure except touch positive lead to screw that is closest to passenger fender on row that has 4 screws. (top left screw)

Ford FICM Repair


Priority 2 Day Shipping $7.00